When we bought our house, the appraiser said the floors on our second floor were ‘detrimental to the value of our home’.
That really ticked my husband and I off.
Sure they were ugly, but detrimental to the value? Come on! Check out how we turned, a negative into a positive when we restored our floors.
So we went and bought new flooring, since we thought we had to replace all the flooring up there. My husband rented a sander, so we could even out the floors. We read there are 2 ways to install new wood flooring: 1. put down sub flooring 2. sand down existing floor so it’s even. (you might even need to sand down before putting the subflooring)
With old homes, a 1 inch thick board, is actually 1 inch thick. When you buy a 1 inch board at the store, it’s 3/8″ thick or 3/4″ thick, it’s less. So your choiceto get a 1 inch board is to go to a mill and have them make boards the correct thickness, or buy a planer and make them yourself. We bought a planer and planed down 2 inch boards down to the correct thickness (we used the shavings for mulch for the garden and flowers)
Determine what boards need to be replaced and cut out the old boards, making sure to steer clear of electrical wires, plumbing and nails. Definitely wear eye and hearing protection, it’s messy. Block off the doors so the dust is contained in one room. Use your saw to cut in between the boards and remove the damaged pieces. Hammers and crow bars are a must. But don’t damage the boards around what you are replacing.
You will need to make sure you cut back the boards to the next floor joist too. (so many things to consider to make it look right).
We found water damaged boards and below them were charred boards, sometimes in the middle of the room (what did these people do!). We sometimes had to take a 2×4 and sister the board (attach it to the one next to it), to give it support.
We had damaged boards in one of the bedrooms that we had to replace. The previous owner had also put the register under the trim and edge of the room. So we moved the register and replaced the boards.
You need to find the joists and cut back to them and feather in (not have all the boards end at the same place), so it looks like it’s been there forever.
If boards aren’t fitting, you can give them a 45 degree cut to help it fit in better.
Last steps once the boards are in, is to sand the boards down so they are even and no lips from the new boards, that you could potentially trip over.
Sand the boards, wipe them down, vacuum up all the dirt and then stain the wood (if you want to stain..no pressure here). Allow it to dry and then put down 3-4 coats of polyurethane(maybe more, depending on how you want it to look). Follow the directions on the cans of stain and polyurethane.
We had 1500 square feet of flooring to complete. It took us 3 months to complete getting it done, working at night and mostly on the weekends. This was mainly my husband doing all the work himself (no crew) and me helping stain and poly while keeping the kids off the floors.